BlueRigger Toslink Digital Optical Audio Splitter 1x2

Overview

A buyer with one optical output and two Toslink devices gets a single small box that takes the male input and feeds two female outputs at once. The passive design splits the light signal rather than regenerating it, so both connected devices receive the same audio stream without any power supply or setting to change. Gold-plated connectors and optical fiber carry the signal with low jitter.

Two destinations from one optical port is the whole point here, and it happens without power, menus or a remote. The split is passive, so the light reaching each device is weaker than what left the source, and long output runs make that worse. Buyers who need every format decoded should check the supported list before ordering.

Who it's for

A living room or media setup where the television has one Toslink port but two pieces of audio gear need the same stream. It also suits a recorder and a receiver sharing a disc player. People whose movies carry newer surround formats should look elsewhere, since those codecs pass through this splitter poorly or not at all.

Pros and cons

Performance notes

Sound quality depends on how much light survives the split and the run to each device. Short output cables keep losses low, and fully seated connectors with an audible click prevent intermittent channels. Because nothing boosts the signal, a weak source or a long cable shows up as dropouts on one or both outputs.

Specifications