YXQ M3 x 0.5mm HSS Metric Hand Taps, 4 Pack
- M3 x 0.5mm metric thread
- HSS high speed steel
- 3 straight flutes, right hand thread
- 4 pieces, taper and plug styles
- 3mm shank
Updated 15 days ago · Based on the Amazon listing and published specifications, not hands-on testing.
A small set of metric hand taps for threading holes in metal and plastic project parts. No tap wrench or drill bit is included, and the listing does not split the taper and plug count.
As an Amazon Associate I earn from qualifying purchases. ProductDome earns a commission when you buy through links on this page.
ASIN: B07G475F2R
Overview
Three straight flutes along each YXQ tap cut fine metric threads and clear chips as you turn it into a pre-drilled hole. High speed steel holds an edge in aluminum, mild steel and plastic, and right-hand threads match standard metric screws of that size.
Spare taps in one common size suit hobby builders who thread small metric holes often and break taps now and then. You still need a tap wrench and the right drill size, neither of which is listed.
Who it's for
Makers fitting small metric screws to brackets, frames and enclosures get spares in the size they use. Mechanics needing many sizes should buy a full set.
Pros and cons
- Common M3 size
- High speed steel
- Straight flutes clear chips
- Multiple spares in one pack
- Tap wrench not included
- Drill size not listed
- Taper and plug split unclear
- Single size only
Performance notes
Straight flutes carry chips out of the hole, but blind holes need backing out often to clear them. A taper tap starts threads gently, while a plug tap cuts closer to the bottom. HSS cuts aluminum and mild steel well but can snap if forced.
Specifications
| Brand | YXQ |
|---|
Frequently asked questions
How long are the YXQ M3 taps?
Each tap has a total length of 42mm with a 3mm shank.
Do the YXQ taps include a tap wrench?
No. The package lists 4 taps only.
Are the YXQ M3 taps left or right hand?
Right hand, matching standard M3 screws.
Can the YXQ taps cut threads in steel?
They are HSS, which cuts metal. Use cutting fluid and turn slowly to avoid snapping a small tap.