Enhon Offset Spot Weld Chisel
- Unit Count: 1
- Blade Material: High Carbon Steel
- Handle Material: Rubber
- Item Dimensions L X W: 9.8 × 1.2 inches
Last refreshed Jun 25, 2026 · Based on the Amazon listing and published specifications, not hands-on testing.
A 9.8 inch offset spot weld chisel in high carbon steel, sharpened on three sides to slice welded body panels in tight spots a pry bar can't reach.
As an Amazon Associate I earn from qualifying purchases. ProductDome earns a commission when you buy through links on this page.
ASIN: B0FJRQ4M5KModel: SO-Enhon-2656Category: Metalworking Chisels
Overview
The Enhon spot weld chisel is a 9.8 inch offset panel removal chisel built from high carbon steel, sharpened on three sides to slice through pressure welded body panels. It is designed for the tight, hard to reach spots where a standard pry bar cannot get purchase.
- 9.8 x 1.2 inch offset chisel body
- Blade sharpened on three sides
- High carbon steel, heat treated for hardness
- Easy grip handle with buffer pad
Who it's for
Suits auto body technicians and DIY collision repair separating spot welded panels, rocker arms, or floor pans in confined spaces. Less suited to anyone expecting the grip to survive heavy hammer use without reinforcing it.
Pros and cons
- Thin offset blade reaches tight panel gaps
- High carbon steel edge holds up to repeated hammering
- Effective for removing floor pans and body panels
- Can be resharpened rather than replaced
- Rubber handle grip tears loose under hard hammer strikes
- Blade can chip on unexpected welds
- Bends if used as a pry bar, though it can be bent back
Specifications
| Brand | Enhon |
|---|---|
| Model | SO-Enhon-2656 |
| Dimensions & fit | |
| Item Dimensions L X W | 9.8 × 1.2 inches |
| Size | 9.84 x 1.18 inches |
| Construction & materials | |
| Blade Material | High Carbon Steel |
| Handle Material | Rubber |
| Included components | |
| Unit Count | 1 |
| Included Components | 1 Spot Weld Chisel |
| Other details | |
| Blade Edge | Straight |
Frequently asked questions
What is the Enhon spot weld chisel used for?
It is built to separate spot welded auto body panels, such as rocker arms, floor pans, and rear side panels, in tight spaces a standard pry bar cannot reach.
Should I drill out the welds before using this chisel?
Yes, drilling out spot welds first, especially on hardened steel, protects the blade edge and makes separation easier.
Does the handle hold up to hammer strikes?
Multiple buyers report the rubber handle grip tears or rips loose on the first hard hammer blow, though the blade itself continues to perform well.